Wide heavy Gauge links Built-in Articulating Elevated Mid-Ottoman
Geometry used to balance chair operation
Handle/lever activated&gravity operated
Handle/lever used for release only
Direct drive with double locks
Direct Drive with double Over-center-locks
Flatter links supporting chair wider base mounting points
Flanged links for stabilzer tubes
Heavy flanges on links in instead of tube
Large diameter cross tubes
Large diameter tubes instead of formedstraps
Extended life rivet joints
Acetal and Bronze rivet bushings
Nylon stop pin bushings
Interchange ablity with omega recliners
Strength, durability, and safety
Maximum safety and comfort
consistent and easy operation for any person
ease of operation & comfort
Maximum synchronization of sides. Positive locking of both sides
Greater bending resistance
greater sability and strength
Maximum strength stability and side-to-side
Reduced wear and increased dura-bility
Profile shape designed for safety and appearance without pinch points.
Articulating design allows use of wider & higher mid-ottoman for elimination of entrapment areas and for leg support.
Occupant's weight used to balance operatopm omstead of springs.
Therefore, the opening, closing, ottoman firmness, and back balance while reclining vary with the weight of the occupant.
Marking the operation consistent from one person to the next.
Springs are used for locking and the initial start of the opening.
Occupant's weight opens chair, handle/lever only unlocks mechanism.
Slight footrest pressure closes ottoman.
Square drive tube connects to and controls both left & right sides.
Improved weight capacity and durability（250 pound occupant weight）
Mechanism base width is closer to seat width while maintaining sufficient clearance between links to eliminate possibility of interference.
Eliminates problems with flexing and breaking of tube end at bend. flange is on heavy gauge link instead of the lighter gauge tube which can flex and break.
Unique design of flattened tube end maximizes torsional strength unlike non-tubular cross members which have no sign of can't torsional strength.
All rivet joints have either acetal（Delrin）or Bronze bushings and acetal spacers to eliminate any steel-to-steel contact No metal-to metal noises when links contact stop pins.
All Recliners are interchangeable in the same frame if the frame is constructed for Rocker and Two-Motor Lift.